OUTER BELT - REAR DOOR - LEFT HAND (Remove and Replace)
Correction code
1170040302
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH rear door and lower the LH rear window.
-
Use a plastic trim tool to release the
rear edge of the LH rear door outer belt seal, and then remove the seal from the
door.
Install
-
Align the LH rear door outer belt onto
the door assembly, and then carefully press the seal downward to install it onto the
door assembly.
- Close the LH rear door and raise the LH rear window.