2025-03-12

BUSBAR - FAST CHARGE CONTACTOR TO DIRECT CURRENT BUSBAR - POSITIVE (Remove and Replace)

Correction code 1630010202 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: BUSBAR FAST CHARGE - INPUT - POSITIVE (Remove and Replace) / BUSBAR FAST CHARGE - INPUT - NEGATIVE (Remove and Replace) / BUSBAR - FAST CHARGE CONTACTOR TO DIRECT CURRENT BUSBAR - POSITIVE (Remove and Replace) / BUSBAR - FAST CHARGE CONTACTOR TO DIRECT CURRENT BUSBAR - NEGATIVE (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes

Bolt that attaches the positive/negative inlet/DC link fastcharge busbar to the fastcharge contactor

15 Nm (11.1 lbs-ft) -180 degrees
5 Nm (3.7 lbs-ft) +60 degrees
  • Insulated Ratchet/torque wrench
  • Insulated 13 mm socket
  • Insulated Torque wrench with angle measurement
Replace 1104475-00-F

Remove

  1. Remove the fastcharge cover. See Cover - FastCharge (Remove and Replace).
  2. Remove and discard the bolt that attaches the positive DC link fastcharge busbar to the fastcharge contactor.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Insulated Ratchet/torque wrench
    • Insulated 13 mm socket
    • Insulated Torque wrench with angle measurement

Install

  1. Install and torque a new bolt that attaches the positive DC link fastcharge busbar to the fastcharge contactor.
    15 Nm (11.1 lbs-ft) -180 degrees
    5 Nm (3.7 lbs-ft) +60 degrees
    Informational PurposesAn informational icon, calling your attention
    Note
    Tighten the bolt to 15 Nm, back off 180 degrees, then torque to 5 Nm + 60 degrees. Mark after torque.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Insulated Ratchet/torque wrench
    • Insulated 13 mm socket
    • Insulated Torque wrench with angle measurement
  2. Install the fastcharge cover. See Cover - FastCharge (Remove and Replace).