DOOR NOISE VIBRATION HARNESS PAD - REAR LEFT HAND (Remove and Replace)
Correction code
1513020302
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
-
Remove the LH rear door trim panel
assembly from the vehicle. See Panel - Door Trim - Rear - LH (Remove and Install).
NoteNo need to separate the harness from the panel.
- Release the LH rear door NVH pad from the tabs (x3), and then remove it from the LH rear door trim panel.
Install
- Install the LH rear door NVH pad to the LH rear door trim panel.
- Install the LH rear door trim panel assembly to the vehicle. See Panel - Door Trim - Rear - LH (Remove and Install).