2025-03-12

HARNESS-FRONT SUBFRAME-ALL WHEEL DRIVE (Remove and Replace)

Correction code 1710070302 FRT 0.35 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Disconnect the LV battery. See LV Power (Disconnect and Connect).
  2. Remove the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  3. Disconnect front subframe harness connector.
  4. Release FDU main harness connector clip from front subframe.
  5. Disconnect FDU inverter logic connector and remove harness clips.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release locking tab then push the handle downward to release connector.
  6. Release FDU harness clips from LH side of front subframe.
  7. Release FDU harness clips from RH side of front subframe.
  8. Disconnect resolver logic connector and remove harness clip.
  9. Remove front subframe harness.

Install

  1. Position front subframe harness to install.
  2. Connect resolver logic connector.
  3. Secure FDU harness clips onto RH side of front subframe.
  4. Secure FDU harness clips onto LH side of front subframe.
  5. Connect FDU inverter logic connector.
  6. Secure FDU main harness connector clip onto front subframe.
  7. Connect FDU front subframe harness connector.
  8. Install the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  9. Connect the LV battery. See LV Power (Disconnect and Connect).