Launcher Bracket - LH (LHD) (Remove and Replace)
Correction code
TBD
FRT
0.35
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts (x2) that attach the launcher bracket to the body |
![]() 9 Nm (6.6 lbs-ft) |
|
Reuse |
Remove
- Remove the wiper module. See Wiper Module (LHD) (Remove and Replace).
- Remove the LH pedestrian protection actuator. See Actuator - Pedestrian Protection - Active Hood - LH (Remove and Replace).
-
Remove the bolts (x2) that
attach the LH launcher bracket to the body.
NoteUse of the following tool(s) is recommended:
- 10 mm socket
- Remove the LH launcher bracket from the vehicle.
Install
- Align the guide tabs (x2) and position the LH launcher bracket to the body.
-
Install the bolts (x2) that attach the LH launcher bracket to the
body.9 Nm (6.6 lbs-ft)NoteUse of the following tool(s) is recommended:
- 10 mm socket
- Install the LH pedestrian protection actuator. See Actuator - Pedestrian Protection - Active Hood - LH (Remove and Replace).
- Install the wiper module. See Wiper Module (LHD) (Remove and Replace).