2025-03-12

TOW HITCH COVER (Remove and Replace)

Correction code 1001050702 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Turn the plastic bolts (x2) that secure the tow hitch cover 90 degrees to release them.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SCREWDRIVER, FLAT TIP, SL6.5, 10.4"
  2. Release the tabs (x2) to remove the tow hitch cover from the rear lower fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pay attention not to damage the guide pins.

Install

  1. Insert the guide pins into the slots, and then secure the tabs (x2) to install the tow hitch cover onto the rear lower fascia.
  2. Turn the plastic bolts (x2) that secure the tow hitch cover 90 degrees to secure them.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SCREWDRIVER, FLAT TIP, SL6.5, 10.4"