2026-08-09

Sensor - Ambient Air Temperature - Heating/Cooling Circuit (Remove and Replace)

Correction code 1001040602 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Remove the bolts (x3) that attach the washer reservoir to the front end carrier, and then move the reservoir aside.
    Note
    Be careful not to spill washer fluid from the reservoir.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Release the tabs (x2) and attach the ambient temperature sensor to the active grille shutter.
  4. Carefully remove the ambient temperature sensor cover from the active grille shutter, and then move the sensor out through the opening.
  5. Disconnect the ambient temperature sensor electrical connector, and then remove the ambient temperature sensor from the vehicle.

Install

  1. Connect the ambient temperature sensor electrical connector.
  2. Feed the ambient temperature sensor through the opening of the active grille shutter, and then install the tabs (x2) that attach the sensor to the active grille shutter.
  3. Install the ambient temperature sensor cover.
  4. Move the washer reservoir back to its original position, and then install the bolts (x3) that attach the washer reservoir to the front end carrier.
    4 Nm (2.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).