2026-04-20
Cover - Left Terminals (7-Seat) (Remove and Replace)
Correction code
TBD
FRT
1.32
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
- 2026-02-27: Released new procedure.
Remove
- Remove the ancillary bay cover. See Cover - Ancillary Bay (7-Seat) (Remove and Replace).
- Remove the pyro disconnect. See Pyro Disconnect - HV Battery (Remove and Replace).
-
Remove the harness clip from the left terminals cover.
-
Release the tabs (x2) and datum to remove the left terminals cover.
Install
-
Align the tabs (x2) and datum, then install the left terminals cover.
-
Install the harness clip to the left terminals cover.
- Install the pyro disconnect. See Pyro Disconnect - HV Battery (Remove and Replace).
- Install the ancillary bay cover. See Cover - Ancillary Bay (7-Seat) (Remove and Replace).