2025-03-17

NVH Pad (Remove and Replace)

Correction code 1601011002 FRT 3.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove penthouse engagement seal from HV battery pack. See Ancillary Bay Engagement Seal.
  2. Use a non marring scraper to remove NVH pads from HV battery.
  3. Clean top surface of high voltage battery pack.
    Informational PurposesAn informational icon, calling your attention
    Note
    Wipe top cover of HV battery pack using IPA wipes in preparation to apply new NVH pads, and wait approximately 1 minute to allow product to dry.

Install

  1. Start from marked end and slowly install pads while pulling away tape backing, verify foam strip is centered prior to applying pressure, Wet out foam strip using pressure roller to ensure full application.
  2. Install penthouse engagement seal to HV battery pack. See Ancillary Bay Engagement Seal.