2025-03-12

UPPER BRIGHT TRIM CAP - LEFT HAND (Remove and Replace)

Correction code 1220010302 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: UPPER BRIGHT TRIM CAP - LEFT HAND (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x8) that attach the LH upper brightwork cap to the body
1.1 Nm (.8 lbs-ft)
  • Torx T20 socket
Reuse

Remove

  1. Remove the LH header seal. See HEADER SEAL - LEFT HAND (Remove and Replace).
  2. Remove the push rivet that attaches the LH upper brightwork cap to the body.
  3. Remove the screws (x8) that attach the LH upper brightwork cap to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. With assistance, remove the LH upper brightwork cap from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start from the front of the trim and work rearward. The rear of the trim engages the rear quarter glass.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage paint and/or quarter glass when removing the trim.
  5. Remove and discard the grommets (x8) from the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the grommet that the push pivot is installed into.

Install

  1. Install new grommets (x8) into the body where the LH upper brightwork will install.
  2. With assistance, carefully position the LH upper brightwork cap onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Starting at the rear quarter glass, ensure the bright trim is fully seated on the dowel protruding out of the rear quarter glass.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage paint and/or quarter glass when removing the trim.
  3. Install the screws (x8) that attach the LH upper brightwork cap to the body.
    1.1 Nm (.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Install the push rivet that attaches the front of the LH upper brightwork cap to the body.
  5. Install the LH header seal. See HEADER SEAL - LEFT HAND (Remove and Replace).