2025-03-12

QUAD CAM CVR UPR (Remove and Replace)

Correction code 1505010202 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: QUAD CAM CVR UPR (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the interior camera to the upper camera cover
0.8 Nm (7 lbs-in)
  • Torx T10 bit
  • BALL TORX, HAND DRIVER, T10
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Replace 1919198-00-A

Remove

  1. Remove the rear view mirror. See REAR VIEW MIRROR (Remove and Replace).
  2. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  3. Release the upper camera cover clips (x4).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not remove the upper camera cover completely, as the electrical harness is still attached to the interior camera.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slightly release the leading edge of the headliner to allow access for removal.
  4. Disconnect the interior camera connectors (x3), and then remove the upper camera cover and interior camera assembly from the vehicle.
  5. Remove and discard the screws (x2) that attach the interior camera to the upper camera cover, and then remove the interior camera from the upper camera cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • BALL TORX, HAND DRIVER, T10
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Install

  1. Position the interior camera onto the upper camera cover, and then install new screws (x2) (1919198-00-A) that attach the interior camera to the upper camera cover.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • BALL TORX, HAND DRIVER, T10
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Connect the interior camera connectors (x3).
  3. Install the upper camera cover clips (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Slightly release the leading edge of the headliner to allow access for installation, and then install the headliner back to original position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Guide the rear view mirror connectors through the opening of the cover.
  4. Connect the LV battery power. See LV Power (Disconnect and Connect).
  5. Install the rear view mirror. See REAR VIEW MIRROR (Remove and Replace).