2025-03-12

Hose - Inlet To Power Control Unit (Remove and Replace)

Correction code 1630011802 FRT 2.28 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.NOTE: See Ergonomic Precautionsfor safe and healthy working practices.

Remove

  1. Remove the HV battery PCS assembly. See Power Conversion System (Remove and Install).
  2. Cut protrusion on the ancillary bay harness base.
  3. Release PCS coolant inlet hose from hose clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the locking tab upward to release. Use a plastic trim tool to help lift the connector upward as necessary.
  4. Disconnect PCS coolant inlet hose from penthouse.

Install

  1. Connect PCS coolant inlet hose to ancillary bay.
  2. Secure PCS coolant inlet hose to hose clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the locking tab upward to release. Use a plastic trim tool to help lift the connector upward as necessary.
  3. Install the HV battery PCS assembly. See Power Conversion System (Remove and Install).