2025-03-12

BRAKE SHIELD - REAR- LEFT HAND - BASE (Remove and Replace)

Correction code 3301020702 FRT 0.50 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH rear hub. See Hub - Rear - LH (Remove and Replace).
  2. Remove the bolts (x3) that attach the LH rear brake shield to the knuckle, and then remove the brake shield from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Torx T30 bit
    • DRIVER KIT, 1/4" HEX, M12
    • Ratchet/torque wrench

Install

  1. Install the bolts (x3) that attach the LH rear brake shield to the knuckle.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Torx T30 bit
    • DRIVER KIT, 1/4" HEX, M12
    • Ratchet/torque wrench
  2. Install the LH rear hub. See Hub - Rear - LH (Remove and Replace).