2025-03-09

Camera - Interior (Remove and Install)

Correction code 1724010101 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Camera - Interior (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the interior camera to the camera upper cover
0.8 Nm (7 lbs-in)
  • Torx T10 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm (installation only)
Replace

Remove

  1. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  2. Remove the quad camera upper cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
  3. Remove and discard the screws (x2) that attach the interior camera to the upper camera cover, and then remove the interior camera from the upper camera cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm (installation only)

Install

  1. Install new bolts that secure interior camera to camera upper cover.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm (installation only)
  2. Install the quad camera upper cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
  3. Connect the LV battery power. See LV Power (Disconnect and Connect).