2025-03-12

Door Reflector (Remove and Replace)

Correction code 1513010502 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.NOTE: See Ergonomic Precautionsfor safe and healthy working practices.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Use a plastic trim tool to release the front door reflector from the rear edge of the front door panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage the door panel.

Install

  1. Install the front door reflector by pushing it into the door panel. Make sure the front door reflector is fully attached.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the "Up" mark is facing up during installation.
  2. Raise the LH front window and close the LH front door.