2026-08-09

Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

Correction code 1145010102 FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
The side impact airbag deployment depends on the rear door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the rear door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the rear doors and their components.

Remove

  1. Remove the LH rear window closeout assembly. See Window Regulator Closeout - Rear Door - LH (Remove and Replace).
    Note
    It is not necessary to remove the pressure sensor, window motor and the window regulator module from the LH rear window closeout assembly.
  2. Disconnect the LH rear door handle connector.
  3. Remove the plugs (x2) that cover access to the LH rear door exterior release handle nuts.
  4. Remove and discard the nuts (x3) that attach the LH rear exterior door handle to the door panel, and then remove the handle from the door.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm deep socket

Install

  1. Position the LH rear exterior door handle to the vehicle, and then hand-tighten new nuts (x3) that attach the exterior door handle to the door panel.
  2. Use the gap and flush tool to check the gap and flush of the handle to the door surface.
    Note
  3. Tighten the nuts (x3) that attach the exterior door handle to the door panel.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
  4. Install the plugs (x2) that cover access to the LH rear door exterior release handle nuts.
  5. Connect the LH rear door handle connector.
  6. Install the LH rear window closeout assembly. See Window Regulator Closeout - Rear Door - LH (Remove and Replace).