2025-01-20

Bracket - Load Floor - LH (Remove and Replace)

Correction code TBD FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the front trunk load floor. See TRUNK LOAD FLOOR - FRONT (Remove and Replace).
  2. Remove the trunk sill trim. See TRUNK SILL LOWER TRIM (Remove and Replace).
  3. Release the tabs (x4) and the clips (x2) to remove the LH load floor bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not adjust the clip position after the bracket is removed. Otherwise, the bracket will not seat properly during installation.

Install

  1. Secure the tabs (x4) and the clips (x2) to install the LH load floor bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Confirm each clip installation with push-pull test to make sure the bracket seats properly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not adjust the clip position after the bracket is removed. Otherwise, the bracket will not seat properly during installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the clip position is changed or the push-pull test shows that the bracket is not secure, remove the clip from the tab, and then seat the clip into the doghouse on the bracket and reinstall.
  2. Install the trunk sill trim. See TRUNK SILL LOWER TRIM (Remove and Replace).
  3. Install the front trunk load floor. See TRUNK LOAD FLOOR - FRONT (Remove and Replace).