2026-08-09

Headlamp Fascia Bracket - RH (SAE) (Remove and Replace)

Correction code 1740020902 FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Headlamp Fascia Bracket - RH (SAE) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the LH fascia bracket to the headlamp assembly
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
 Reuse

Remove

  1. Remove the front fascia assembly. See Front Fascia (Remove and Install).
  2. Remove the screws (x4) that attach the RH fascia bracket to the headlamp assembly, and then remove the bracket from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the RH fascia bracket to the headlamp, and then install the screws (x4) that attach the RH fascia bracket to the headlamp assembly.
    1.8 Nm (1.3 lbs-ft)
    Note
    Before installation, please verify that the four rubber pads on the back of the bracket are present and not missing.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Install the front fascia assembly. See Front Fascia (Remove and Install).