2024-11-11

Headlamps - Global Headlamp - LH (Remove and Replace)

Correction code 1740010202 FRT 0.5 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Headlamp Assembly - Pair (Remove and Install) and
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the LH headlight to the body
3.5 Nm (2.6 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Remove the front fascia assembly. See FRONT FASCIA (Remove and Install).
  2. Disconnect the electrical connector from the LH headlight.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  3. Remove the bolts (x3) that attach the LH headlight to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Install the bolts (x3) that attach the LH headlight to the body.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the electrical connector to the LH headlight.
  3. Install the front fascia assembly. See FRONT FASCIA (Remove and Replace).