INNER BELT SEAL - FRONT DOOR - LEFT HAND (Remove and Replace)
Correction code
1170020102
FRT
0.15
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts (x3) that attach the trim panel to the LH front door |
![]() 6 Nm (4.4 lbs-ft) |
|
Reuse |
Remove
- Open the LH front door, and lower the LH front window.
- Remove the LH tweeter. See Tweeter - Front Door - LH (Remove and Replace).
- Remove the LH front door reflector. See DOOR REFLECTOR (Remove and Replace).
-
Remove the bolts (x3) that
attach the trim panel to the LH front door.
TIpUse of the following tool(s) is recommended:
- Torx T30 socket
- Use a plastic trim tool to insert the inflatable air bag to the lower left corner of the LH front door trim, then inflate it to release the lower left clip(s).
-
Continue to pull and release
all of the clips around the edge of the trim panel, working from the bottom
up.
CAUTIONDo not pull the trim panel far away from the door as the panel is still attached by connectors and cables.
-
Put the LH front door trim panel on a padded and stable support.
CAUTIONDo not pull the trim panel far away from the door as the panel is still attached by connectors and cables.
- Release the clips (x3) that attach the rear of the LH front door inner belt seal to the front door closeout, and then pull up to release the inner belt seal.
Install
- Press the LH front door inner belt seal downwards into the LH front door.
- Install the clips (x3) that attach the LH front door inner belt seal to the front door closeout.
- Lift the trim panel, compress the LH front door inner belt seal slightly, and then hook the trim panel tabs into the top edge of the door.
-
Fasten the clips that attach
the trim panel to the door.
NoteReplace any broken clips.
- Make sure that the trim panel fits tightly, and that there are no gaps from misaligned or bent clips.
-
Install the bolts (x3) that
attach the trim panel to the LH front door.6 Nm (4.4 lbs-ft)CAUTIONMake sure that all fasteners are properly torqued and not cross-threaded.TIpUse of the following tool(s) is recommended:
- Torx T30 socket
- Install the LH front door reflector. See DOOR REFLECTOR (Remove and Replace).
- Install the LH tweeter. See Tweeter - Front Door - LH (Remove and Replace).
- Close the door and verify the operation of the manual door release lever, that the door latch releases smoothly and easily.
- Raise the LH front window and close the door.