2025-05-11

Lower Front Fascia (Remove and Replace)

Correction code 1001031202 FRT 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Lower Front Fascia (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) securing front fascia lower assembly to front fascia upper assembly
2.5 Nm (1.8 lbs-ft)
  • Torx T40 socket
  • 4 in extension
 Reuse

Remove

  1. Remove the front fascia grille from fascia. See Grille - Front Fascia (Remove and Replace).
  2. Remove bolts securing front fascia lower assembly to front fascia upper assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
    • 4 in extension
  3. Use a clip tool to remove front fascia lower assembly.
  4. Remove the 10 nuts from front fascia lower assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    For the middle nuts, push both side lock pieces to release the nuts.

Install

  1. Install the 10 nuts to front fascia lower assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    For the middle nuts, push both side lock pieces to release the nuts.
  2. Install front fascia lower assembly.
  3. Install bolts securing front fascia lower assembly to front fascia upper assembly.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
    • 4 in extension
  4. Install the front fascia grille to fascia. See Grille - Front Fascia (Remove and Replace).