2026-04-30

Sensor - Occupancy - 1st Row (Remove and Replace)

Correction code 2005010702 FRT 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
Note
If the foam pad is damaged during occupancy sensor and/or heat pad removal, replace the foam pad.

Install

  1. Remove the adhesive film from the new occupancy sensor.
  2. Route the connector of the occupancy sensor through the notch of the new foam and connect it, and then stick the sensor onto the new foam.
  3. Remove the double-sided tape on the back, and then stick the new seat cushion heat pad onto the new foam pad.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the heat pad is flat.
  4. Install the cushion trim onto the driver seat cushion, and then install the cushion to the vehicle. See Soft Trim Cover - Seat Cushion - 1st Row - LH (Remove and Replace).