2025-01-20

Support Bracket - Display - LH (Remove and Replace)

Correction code TBD FRT 1.38 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Support Bracket - Display - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that secure the LH display support bracket
3 Nm (2.2 lbs-ft)
  • Torx T20 bit
Reuse

Remove

  1. With assistance, release the tabs and remove the instrument panel upper carrier assembly from the vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not separate the components from the upper carrier assembly. Just remove the assembly from the vehicle.
  2. Remove the screws (x2) that secure the LH display support bracket, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Install the screws (x2) that secure the LH display support bracket.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Install the instrument panel upper carrier to the vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).