Tail Lights - Lamp- Rear License Plate (Remove and Replace)
Correction code
1740030402
FRT
0.35
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the rear fascia assembly. See Assembly - Fascia and Diffuser - Rear (Remove and Install).
-
Disconnect the LH rear license plate
lamp connector.
-
Use a small flat head screw driver to
release the clips (x2) that attach LH rear license plate lamp to the rear fascia
assembly, and then remove the lamp from the vehicle.
Install
-
Install the clips (x2) that attach LH
rear license plate lamp to the rear fascia assembly.
-
Connect the LH rear license plate lamp
connector.
- Install the rear fascia assembly. See Assembly - Fascia and Diffuser - Rear (Remove and Install).