2025-05-26

Assembly - Instrument Panel - Lower (Remove and Replace)

Correction code 1405011092 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Assembly - Instrument Panel - Lower (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the instrument panel lower assembly to the instrument panel carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 bit
 Reuse

Remove

  1. Remove the LH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).
  2. Remove the driver footwell hush panel. See Hush Panel - Footwell - Driver (Remove and Replace).
  3. Remove the screw that attaches the instrument panel lower assembly to the instrument panel carrier.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  4. Release the tabs (x13) to remove the instrument panel lower assembly from the vehicle.

Install

  1. Engage the tabs (x13) to install the instrument panel lower assembly.
  2. Install the screw that attaches the instrument panel lower assembly to the instrument panel carrier.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  3. Install the driver footwell hush panel. See Hush Panel - Footwell - Driver (Remove and Replace).
  4. Install the LH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).