Armrest Inner Assembly - Center Console (Model YL) (Remove and Replace)
Correction code
15190200902
FRT
0.66
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
-
Remove the rear end module. See Rear End Module - Center Console (Model YL) (Remove and Install).
NoteDuring removal, certain steps require extra care. See the animation(s) for detailed guidance.
- Remove the armrest. See Center Console - Armrest Assembly (Remove and Replace).
-
Release the clips and datums to remove the armrest inner assembly.
NoteStart to release the clips from the front edge of armrest, and then work towards the hinge side. Put the trim tool as close to the clip as possible when releasing the clips. Be careful not to damage the clips. Discard the part if any damage occurs.
Install
-
Align the datums on the inner assembly to the holes on the armrest, and then secure
the clips that attach the armrest inner assembly to the armrest.
NoteInstall a new part if the original part had any damage during removal. Ensure the inner assembly engages well to the hinge arms.
- Install the armrest. See Center Console - Armrest Assembly (Remove and Replace).
- Install the rear end module. See Rear End Module - Center Console (Model YL) (Remove and Install).