Bracket - Front License Plate - EMEA (Install)
Correction code
1207010106
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Equipment:
- 1054782-00-A - ZEP 99% IPA 1 gallon - Case of 4 bottles
- 2132210-00-A - Front Large license plate bracket EMEA, 2025+ MY
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Screws (x4) that attach the front license plate bracket to the front fascia |
![]() 3 Nm (2.2 lbs-ft) |
|
Reuse |
Procedure
-
Clean the front fascia
surface in preparation for installation of the front license plate bracket,
and allow 1 minute to dry.
TIpUse of the following tool(s) is recommended:
- 1054782-00-A - ZEP 99% IPA 1 gallon - Case of 4 bottles
-
Install the front license
plate bracket to the alignment tool.
TIpUse of the following tool(s) is recommended:
- 2132210-00-A - Front Large license plate bracket EMEA, 2025+ MY
-
Install the front license
plate bracket to the front fascia.
NoteAlign the tool with the fascia grill at the middle vertical and the second horizontal grill bars.
-
Install the screws (x4) that
attach the front license plate bracket to the front fascia, and then remove
the license plate bracket tool.
3 Nm (2.2 lbs-ft)NoteDo not over torque the screws to prevent damage to the front fascia.TIpUse of the following tool(s) is recommended:- 8 mm 12-point deep socket