2026-04-30

Switch - Power Recline - 2nd Row - LH (Remove and Replace)

Correction code 1305031402 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Switch - Power Recline - 2nd Row - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the power recline switch to seat cushion
1 Nm (.7 lbs-ft)
  • 10 mm socket
  • Ratchet/torque wrench
  • 4 in extension
Reuse
Bolts (x2) that attach the power recline switch to the switch plastic assembly
0.7 Nm (6 lbs-in)
  • 4 in extension
  • Ratchet/torque wrench
  • Torx T20 bit
Reuse

Remove

  1. Remove the 2nd row seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).
  2. Remove the bolts (x2) that attach the power recline switch to the seat cushion.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Ratchet/torque wrench
    • 4 in extension
  3. Disconnect the power recline switch connector.
  4. Remove retaining clips (x3) from seat cushion foam.
  5. Remove the power recline switch assembly from the LH cushion switch bezel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a small pocket screwdriver to push two tabs outward, then gently pry at the four grooves.
  6. Remove LH rear seat fold switch plastic assembly from cushion assembly.
  7. Remove the bolts (x2) that attach the power recline switch from the switch plastic assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Ratchet/torque wrench
    • Torx T20 bit

Install

  1. Install the bolts (x2) that attach the power recline switch to the switch plastic assembly.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 4 in extension
    • Ratchet/torque wrench
    • Torx T20 bit
  2. Install the power recline switch plastic assembly to the cushion assembly.
  3. Install the power recline switch assembly to the LH cushion switch bezel.
  4. Install the retaining clips (x3) to the seat cushion foam.
  5. Connect the power recline switch connector.
  6. Install the bolts (x2) that attach the power recline switch to the seat cushion.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Ratchet/torque wrench
    • 4 in extension
  7. Install the 2nd row seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).