2025-03-12

Dual Motor Badge (Remove and Replace)

Correction code 1205010402 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1453028-00-A KIT, BADGE REMOVAL
  • 2091866-00-A REAR DM BADGE JIG

Remove

Informational PurposesAn informational icon, calling your attention
Note
The badge cannot be reinstalled if removed. If the badge is removed for any reason, it must be replaced with a new part.
  1. Prepare the badge removal tool with approximately 60 centimeters of monofilament line.
  2. Tie slip knots at both ends of the monofilament line and attach them each to the center groove of a handle.
  3. Insert the monofilament line between the vehicle configuration badge and the liftgate.
  4. Move the badge removal tool in a sawing motion to separate the vehicle configuration badge from the liftgate.
  5. Use IPA wipes to clean all adhesive residue and debris from the liftgate surface.

Install

  1. Slowly peel the vehicle configuration badge backing, and then position the badge onto the fixture alignment pins.
  2. Open the liftgate partially.
  3. Position the badge fixture onto the RH rear of the liftgate, and make sure the lower and right edges of the fixture align with the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Hold the fixture during the installation to prevent it from falling.
  4. Press the vehicle configuration badge onto the liftgate.
  5. Remove the protective film from the badge, and then remove the fixture from the liftgate.
  6. Close the liftgate.
  7. Replace the protective film over the badge, use a pressure roller to wet-out the badge, and then remove the protective film.
  8. Use an IPA wipe to clean the badge and any remaining debris.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all edges of the badge are securely affixed to the liftgate.