2026-08-09

Instrument Panel Riser - RH (Remove and Replace)

Correction code 1405020702 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Instrument Panel Riser - RH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt and nut that secure the RH instrument panel riser bracket
25 Nm (18.4 lbs-ft)
  • 13 mm socket
 Reuse

Remove

  1. Remove the center console assembly. See Center Console (Remove and Install).
  2. Remove the clip that attaches the RH instrument panel riser bracket to the console duct.
  3. Remove the bolt and nut that secure the RH instrument panel riser bracket, and then release the harness clip and remove the riser bracket from the vehicle.
    Note
    Pull the RH carpet edge to remove the nut.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Install the harness clip, and then install the bolt and nut that secure the RH instrument panel riser bracket.
    25 Nm (18.4 lbs-ft)
    Note
    Pull the RH carpet edge to install the nut.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Install the clip that attaches the RH instrument panel riser bracket to the console duct.
  3. Install the center console assembly. See Center Console (Remove and Install).