2nd Row Seat 5 Seater - RH (Remove and Replace)
Correction code
1305010402
FRT
0.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts that attach the 2nd row 60/40 seat frame to body |
![]() 37 Nm (27.3 lbs-ft) |
|
Replace | 1616775-00-B |
Remove
- Remove the 2nd row 40 seat assembly from the vehicle. See 2nd Row Seat 5 Seater - RH (Remove and Install).
Install
- Install the 2nd row 40 seat assembly onto the vehicle. See 2nd Row Seat 5 Seater - RH (Remove and Install).
- Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect).
- In Toolbox 3.0, click the Actions tab, type "Recline" into the search field, click PROC_VCRIGHT_X_2R-SEAT-RECLINE-CALIBRATIONvia Toolbox: (link)via Service Mode: Low Voltage ➜ Second Row Seats ➜ Calibrate, click Run, and allow the routine to complete.
- Exit Service Mode Plus and disconnect the laptop from the vehicle. See Service Mode Plus.