2026-08-09

VCUSB Assembly - Center Console (Model YL) (Remove and Install)

Correction code 15190200101 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: VCUSB Assembly - Center Console (Model YL) (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x4) that attach the VCUSB to the center console
1.2 Nm (.9 lbs-ft)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. Remove the rear end module assembly. See Rear End Module - Center Console (Model YL) (Remove and Install).
    Note
    During removal, certain steps require extra care. See the animation(s) for detailed guidance.
  2. Disconnect the VCUSB module connector.
  3. Remove the bolts (x4) that attach the VCUSB to the center console.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Install

  1. Align the datum on the VCUSB to the hole on the center console, and then install the bolts (x4) that attach the VCUSB to the center console.
    1.2 Nm (.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Connect the VCUSB module connector.
  3. Install the rear end module assembly. See Rear End Module - Center Console (Model YL) (Remove and Install).