2025-03-12

SKULL CAP - EXTERIOR MIRROR - LEFT HAND (Remove and Replace)

Correction code 1209010702 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Use a plastic trim tool to release the front outboard edge of the door mirror skull cap.
  2. Lift the door mirror skull cap upwards to release the remaining tabs that attach it to the door mirror assembly, and then remove the door mirror skull cap from the door mirror assembly.

Install

  1. Position the door mirror skull cap over the door mirror assembly, and align the skull cap tabs to the door mirror assembly.
  2. Push down on the top of the door mirror skull cap to fasten the tabs that attach it to the door mirror assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press at the inside and outside edges of the skull cap, until an audible click is heard.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the gaps between the inner perimeter of the skull cap and door mirror assembly are within specification.