2025-01-23

Exterior Door Handles - Rear Door Handle Sensor - LH (Remove and Replace)

Correction code NEW FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove and disconnect LH rear outer door handle connector. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).
  2. Remove LH rear door handle sensor.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T20 socket
    • Installation only: TORQ WRNCH,DIG+ANG,1/4"DR,FIXHD,1.5~30Nm

Install

  1. Install LH rear door handle sensor.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T20 socket
    • Installation only: TORQ WRNCH,DIG+ANG,1/4"DR,FIXHD,1.5~30Nm
  2. Install and connect LH rear outer door handle connector. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).