2025-03-12

CONSOLE - REAR AIR VENT PAN - PREMIUM (Remove and Replace)

Correction code 1519010202 FRT 0.45 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: CONSOLE - REAR AIR VENT PAN - PREMIUM (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the air wave assembly to the vent cover panel
0.8 Nm (7 lbs-in)
  • Torx T20 socket
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the rear display. See Touchscreen - Rear Display (Remove and Install).
  2. Use a plastic trim tool to release the clips and tabs that attach the USB bezel to the vent cover panel.
  3. Remove the screws (x2) that attach the air wave assembly to the vent cover panel.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Release the clips (x3) that attach the vent cover panel air wave assembly, and then remove the panel from the vehicle.

Install

  1. Position the vent cover panel to the air wave assembly, and then install the clips (x3) that attach the panel air wave assembly.
  2. Install the screws (x2) that attach the air wave assembly to the vent cover panel.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the clips and tabs that attach the USB bezel to the vent cover panel.
  4. Install the rear display. See Touchscreen - Rear Display (Remove and Install).