2026-08-09

Buckle - 1st Row - LH (Remove and Replace)

Correction code 2005010402 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Buckle - 1st Row - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the buckle to the cushion frame
40 Nm (29.5 lbs-ft)
  • Torx T50 socket
 Replace 1117250-00-A

Remove

  1. Remove the driver seat inboard sideshield. See 1st Row Inboard Sideshield - LH (Remove and Replace).
  2. Disconnect the driver seat buckle electrical connector.
  3. Release the tab, then remove and discard the patch bolt that attaches the buckle to the cushion frame.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  4. Remove the driver seat belt buckle.

Install

  1. Place the driver seat belt buckle to installation position.
  2. Install a new patch bolt to attach the buckle to the cushion frame, and then secure the tab.
    40 Nm (29.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  3. Connect the driver seat buckle electrical connector.
  4. Install the driver seat inboard sideshield. See 1st Row Inboard Sideshield - LH (Remove and Replace).