2025-12-25

Door Latch - Front - LH (Remove and Replace)

Correction code 1133020102 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-12-25: Added steps to perform a door self-test routine.

Torque Specifications

Table 1. Torque Specifications: Door Latch - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the LH rear door latch to the rear of the LH rear door
13 Nm (9.6 lbs-ft)
  • Torx T30 socket
 Reuse

Remove

  1. Remove the LH front door closeout panel assembly. See Closeout Panel - Window Regulator - Front Door - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the LH front door pressure sensor, window motor, door speaker and the window regulator from the door closeout panel assembly.
  2. Disconnect the LH front door electrical harness from the LH front door latch connector.
  3. Remove the bolts (x3) that attach the LH front door latch to the front of the LH front door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  4. Press the latch cable grommet in through the door, and move the cable in through the opening while simultaneously removing the latch from the door.

Install

  1. Feed the latch cable through the opening, and then install the grommet.
  2. Install the bolts (x3) that attach the LH front door latch to the front of the LH front door.
    13 Nm (9.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  3. Connect the LH front door electrical harness to the LH front door latch connector.
  4. Install the LH front door closeout panel assembly. See Closeout Panel - Window Regulator - Front Door - LH (Remove and Replace).
  5. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  6. In Toolbox 3.0, click the Actions tab, type "Self Test" into the search field, click TEST-SELF_VCLEFT_FRONT-L_DOORvia Toolbox:(link), click Run, and allow the routine to complete.
  7. Exit Service Mode or disconnect the laptop if applicable (see 0005 - Service Modes).