2025-02-12

CCS2 - Charge Port (Remove and Replace)

Correction code 4401010302 FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove charge port assembly. See NACS - Charge Port (Remove and Replace).
  2. Disconnect charge port harness from charge port ECU.
  3. Release charge port door harness grommet from body.
  4. Release lower clips securing charge port door from vehicle.
  5. Gently pull the charge port door away from the body to remove the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the assembly towards the rear of the vehicle, when the door actuator reaches to the rear of the quarter panel pull the charge port down to clear the actuator mechanism then pull out and away from the body.

Install

  1. Install charge port door onto vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the part by pivoting the assembly so the actuator mechanism clears underneath the quarter panel, then slide the charge door forward toward the rear door. Manipulation the charge door may be necessary to fully align the assembly to the body
  2. Secure charge port door harness grommet to body.
  3. Connect charge port door connector to charge port ECU.
  4. Install charge port assembly. See NACS - Charge Port (Remove and Replace).