INSTRUMENT PANEL - NOISE VIBRATION HARNESS PAD - DRIVER (Remove and Replace)
Correction code
1405011502
FRT
1.40
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the instrument panel upper carrier from vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).
- Remove instrument panel noise vibration pad from instrument panel driver side.
Install
- Install instrument panel noise vibration pad onto instrument panel driver side.
- Install the instrument panel upper carrier to vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).