2024-12-24

Side Panel - Rear - Center Console - LH (Remove and Replace)

Correction code TBD FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).
  2. Move the LH front seat backward and adjust the seat back to a lower position.
  3. Use a trim pry tool to release the clips (x12) and the tabs (x2) to remove the center console LH rear side panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start from the upper right corner, and then release the remaining clips along each side in turn. Do not damage the center console during moving the side panel.

Install

  1. Secure the clips (x12) and the tabs (x2) to install the center console LH rear side panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure all the clips seat properly. Do not damage the center console during moving the side panel.
  2. Move the LH front seat forward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust the seat back if needed to avoid contacting the headliner.
  3. Install the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).