2026-01-08

Splitter - Front Fascia (Performance) (Remove and Install)

Correction code 10010202201 10010202202 FRT 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the front fascia assembly from the vehicle. See Front Fascia (Remove and Install).
  2. Remove the bolts (x6) that attach the front valance to the front fascia assembly and release the locking tabs (x6).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  3. Release the clips (x10) and datums (x3) that attach the splitter to the lower front fascia.

Replace

  1. Align the datums (x3), and then secure the clips (x10) that attach the splitter to the lower front fascia.
  2. Install the bolts (x6) that attach the front valance to the front fascia assembly and secure the locking tabs (x6).
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  3. Install the front fascia assembly to the vehicle. See Front Fascia (Remove and Install).