Harness - Car Computer(Remove and Replace)
Correction code
1710010802
FRT
0.2
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Disconnect the LV power. See LV Power (Disconnect and Connect).
- Remove the RH A-pillar lower trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
- Release the RH front cabin carpet cover from the RH footwell hush panel, and disconnect the electrical connector.
- Release the clip that attaches the jumper harness to the car computer.
- Disconnect the jumper harness upper connectors (x2) from the car computer.
- Disconnect the harness connectors (x2) from the right side of the car computer.
- Disconnect the jumper harness lower connectors (x2) from the car computer, and then remove the harness from the vehicle.
Install
- Position the harness to the vehicle, and then connect the jumper harness lower connectors (x2) to the car computer.
- Connect the jumper harness upper connectors (x2) to the car computer.
- Install the clip that attaches the jumper harness to the car computer.
- Connect the harness connectors (x2) to the right side of the car computer.
- Connect the electrical connector, and then install the RH front cabin carpet cover to the RH footwell hush panel.
- Install the RH A-pillar lower trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
- Connect the LV power. See LV Power (Disconnect and Connect).