Seal - Axle - Rear Drive Unit - LH (4DU) (Remove and Replace)
Correction code
4001010802
FRT
0.80
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
- 1454928-00-A TOOL, SEAL PULLER, ADJUSTABLE, MS/MX/M3
- 1131206-00-A Install Tool, Output Seal, Model 3
Remove
- Remove the LH rear drive unit halfshaft. See HALFSHAFT - REAR - 28MM X 580MM SHAFT (Remove and Replace).
- Use the adjustable seal puller tool to remove the LH output seal from the rear drive unit.
Install
-
Use the seal install tool to install
the new seal into the rear drive unit.
NoteFully tap around the seal install tool to install the new seal. Make sure that the seal is fully flush with the rear drive unit casting.
- Install the LH rear drive unit halfshaft. See HALFSHAFT - REAR - 28MM X 580MM SHAFT (Remove and Replace).