2025-03-19

Applique - Liftgate (Remove and Replace)

Correction code 1220010902 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Applique - Liftgate (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that secure the liftgate applique
1.5 Nm (1.1 lbs-ft)
  • Torx T20 socket
 Reuse

Remove

  1. Remove the tail lamp. See Tail Lamp - Liftgate - Trunk - LH (Remove and Install).
  2. Remove the clips and bolts that secure the liftgate applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Install the clips and bolts that secure the liftgate applique.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the tail lamp. See Tail Lamp - Liftgate - Trunk - LH (Remove and Install).