2026-01-22

Sensor - Seat Track Position - 1st Row - RH (Remove and Replace)

Correction code 2020020012 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the RH front door.
  2. Move the RH front seat backward.
  3. Disconnect the seat track position sensor connector.
  4. Remove the seat track position sensor from the seat track assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the seat track position sensor to the seat track assembly and install the screw.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Connect the seat track position sensor connector.
  3. Move the RH front seat to original position.
  4. Close the RH front door.