2026-08-13

Primary Body Seal - Rear - LH (Remove and Replace)

Correction code 1170010402 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-08-13: Added notes to verify that the primary seal is installed behind the header seal.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Pull on the LH primary rear side body seal to remove it from the vehicle.
    Note
    Start in the area adjacent the lower left corner of the quarter glass.

Install

  1. Loosely install the LH primary rear side body seal to the body.
  2. Align the joint line of the LH primary rear side body seal to the marking on the B-pillar.
  3. Tuck the seal into the bright molding, and make sure that it fits properly to the trim panels and the headliner.
  4. Press the seal into the lower corners, and then install the rest of the seal to the body.
    Note
    Stretch and tuck the seal so that it is evenly distributed around the perimeter.
    Note
    Make sure that the primary seal is installed behind the header seal.
  5. Raise the LH rear window and close the LH rear door.