2025-08-25

Touchscreen - Rear Display (Remove and Install)

Correction code 2107010201 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Touchscreen - Rear Display (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x5) that attach the rear display to the rear end module
1.2 Nm (.9 lbs-ft)
  • Torx T20 bit
Replace 1096312-00-A

Remove

  1. Remove the center console rear end module. See Module - Rear End - Center Console (Remove and Install).
  2. Remove and discard the bolts (x5) that attach the rear display to the rear end module, and then remove the rear display.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the rear display to the rear end module, and then install new bolts (x5) that attach the rear display to the rear end module.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Install the center console rear end module. See Module - Rear End - Center Console (Remove and Install).