2026-06-25

Microswitch - Hood Latch and Release (Remove and Replace)

Correction code 11351100302 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-06-25: Released new procedure.

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Disconnect the hood latch connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the tab to release the lock then pull again to release the connector. Do not press down on the red tab.
  3. Remove the screw that attaches the hood latch microswitch to the vehicle, then release the location pins (x3) to remove it.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • BIT, T8 TORX, 25MM

Replace

  1. Align the location pins (x3), then install the screw that attaches the hood latch microswitch to the vehicle.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not touch the spring clips on the top of the microswitch.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • BIT, T8 TORX, 25MM
  2. Engage the locking tab, then connect the latch connector.
  3. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  4. Enable Service Mode and unlock the gateway. See Gateway (Unlock).
  5. Perform the following routine using Service Mode or Toolbox: PROC_VCFRONT_X_RESET-FRUNK-OPEN-FAIL-METRICvia Service Mode Plus:Closures ➜ Frunk ➜ Frunk Latch Metric Resetvia Toolbox:(link)
  6. Exit Service Mode.