Knee Impact Foam - Instrument Panel- RH (Remove and Replace)
Correction code
1405011402
FRT
0.4
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screws (x3) securing IP assembly to cross car beam on lower LH side |
![]() 2.3 Nm (1.7 lbs-ft) |
|
Reuse |
Remove
- Remove the lower assembly from IP carrier. See Assembly - Instrument Panel - Lower (Remove and Replace).
-
Remove screws securing IP assembly to
cross car beam on lower LH side.
TIpUse of the following tool(s) is recommended:
- Torx T20 bit
-
Remove RH knee impact foam.
NotePull IP carrier rearward as needed.
Install
-
Install LH knee impact foam.
NotePull IP carrier rearward as needed.
-
Install screws securing IP assembly to
cross car beam on lower LH side.2.3 Nm (1.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 bit
- Install the lower assembly to IP carrier. See Assembly - Instrument Panel - Lower (Remove and Replace).