2026-08-09

1st Row Seat - LHD - RH (Remove and Replace)

Correction code 1304010202 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Install

  1. Install the front passenger seat. See 1st Row Seat- LH (Remove and Install).
  2. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  3. In Toolbox, click the Actions tab, type "Seat Calibration" into the search field, click PROC_VCRIGHT_SEAT-CALIBRATEvia Service Mode:Low Voltage ➜ Seats ➜ Calibrate Seatvia Toolbox:(link), click Run, and allow the routine to complete.
  4. Disconnect the laptop.
  5. Exit Service Mode. See Service Mode.
  6. Move the RH front seat to original position.
  7. Raise both front windows and close both front doors.